The iPod Nano MP3 60GB model has been improved so battery life is up to 20 hours on one charge. As with all electronics, the battery for this MP3 player needs recharging and will eventually have to be replaced. Batteries can be purchased at retail and online stores. Apple recommends that new batteries be installed at participating iPod Nano retailers. Some iPod Nano users purchase the battery and install it at home.
Tools Needed
Two nylon tools, knife or scissors are needed for battery replacement. Light- or medium-weight guitar picks have also been suggested. Metal tools will damage the iPod case and should never be used. The power to the iPod must be turned off before starting.
Opening the iPod
The player should be held flat and face up. Insert the tool between the metal back and acrylic lip on the side front. Pry open just enough to make a space allowing the second tool to be inserted. Run the second tool around the entire edge, which will cause the metal back to separate from the front. Once the back has separated, turn the iPod over and carefully remove the back cover.
Removing the Battery
Three wires covered with colored plastic insulation are soldered to the iPod and connected to the battery. These wires should be cut with a knife or scissors. The cuts should be as close to the battery as possible to leave room for error. Strip the insulation 1/2 inch from the end of the three wires soldered to the iPod. Take out and discard the old battery.
Install New Battery
On the new battery, there are three thin wires that are stripped 1/4 inch. These wires usually have white, orange and black plastic insulation matching the wires soldered to the player. Carefully remove an additional 1/2 inch of insulation without cutting into the wires. A wire stripper works best for this task, but a sharp razor knife or scissors can be used. There are two methods to connect the new battery. The first involves twisting each set of old and new wires together by color. Cover each set of wires with tape, making sure no wire is left exposed. Soldering the wires together is another option, but it is not recommended because the heat from the soldering iron can damage the components in the iPod.
Complete the Replacement
Lay the three sets of wires flat on the main board. Align the front and back so the hold switch lines up with the case, and the iPod will snap together. The new battery should be fully charged before use.
Related posts
Save some cash and change your 60GB iPod battery yourself.The first 60GB iPod was the fourth-generation iPod Classic, and it was also the first iPod to display photos. It was originally released i...
The second generation iPod Shuffle was released in 2006, and units that were purchased new at that time might be experiencing decreased battery life. Learning about how the battery works can help...
iPod Nano won't turn onThere are several reasons why your iPod Nano may not turn on or awake out of its "Sleep Mode." This can be extremely irritating if you wish to use your iPod Nano,...
Add music to your iPod Nano without iTunes.While transferring songs from your computer to your iPod Nano normally requires synchronization through the default iTunes program, you can also sync med...
Turning off the iPod Nano is a simple process, if not an obvious one.iPods have no traditional on/ff switch. They power up with the slightest touch, which makes turning the iPod on as simple as to...
